Reducing Data Generation in Simulations
Running simulations often results in the creation of huge amounts of data. While some of this data is necessary for latter analysis, other data might be temporary or unnecessary, contributing to unnecessary storage and transfer costs.
Below are some steps that can help you reduce the amount of data generated by a simulation and, ultimately, lower your storage and transfer expenses.
Step 1: Configure the Simulator to Generate Less Data
Many simulators allow users to configure how much data is generated during a simulation. By adjusting these settings, you can potentially reduce the amount of unnecessary data that is created. Consider the following options:
Limit the outputs: Check if the simulator allows you to specify the outputs you need. For example, you may only need results at certain time steps or specific variables. Limiting the outputs can greatly reduce the volume of generated data.
Adjust output frequency: If the simulator writes results at frequent intervals, consider reducing the frequency of these writes.
By configuring your simulator to generate only the data you truly need, you can significantly reduce the overall data footprint of your simulation.
Step 2: Clean Up After the Simulation
Once your simulation is completed, you might end up with a large number of temporary or intermediate files that are no longer needed. Running a cleanup after the simulation can free up valuable storage space.
Some simulators allow you to run specific commands after the simulation ends to delete unwanted files.
Example: OpenFOAM
OpenFOAM, creates a separate folder for each process running the simulation. Each process generates data specific to that run, but in the end, OpenFOAM combines all of the process data into a single directory. Therefore, the process folders themselves may no longer be needed after the simulation completes.
Since OpenFOAM uses a shell script to execute the simulation, you can add cleanup commands to the end of the shell script. These commands will delete unwanted files, such as the process-specific folders, to free up storage space.
Keep this tips in mind when running your next simulation to reduce the amount of data generated, keeping your storage and transfer costs in check.